 |
|
|
| Home > Products > Cameras > PTZ Dome Cameras > Installation Guide |
|
Standard Pendant Model Environmental Pendant Model |
Spectra IV Series Spectra IV SE Series |
| 1 | Install the mount for the pendant dome. Refer to the instructions supplied with the mount. |
| 2 | Open the hinged door to the back box. Push the tab lock towards the wall of the unit and lift the door open. Pull wiring into the back box. |
| 3 | Screw the back box onto the mount. If outdoors, apply thread compound (provided) to the threads on the back box. |
| 4 |
Connect the wiring to the circuit board inside the back box. When finished, close the door to the back box and turn on the power. The green LED will light. Note: Aux 1 - Maximum 2A at low voltage (<40V) Aux 2 - Maximum 30mA at 32VDC |
| 5 | Attach the back box leash to the lower dome. |
| 6 |
Set the receiver address and system baud rate by configuring DIP switches SW1 and SW3 located on the side of the dome drive. For DIP switch settings, refer to the labels located on the top of the dome drive or to the Switch Settings Manual included with the package.
Note: When connecting more than one Spectra dome to a single controller, terminate the unit farthest from the controller. To terminate the dome drive set the SW2 switch to the ON position. |
| 7 | Install the dome drive. Line up the blue (A) and red (B) tabs with the blue (A) and red (B) labels. Push in on the tabs. Insert one side and then the other side. Continue pushing on the ends of the tabs until both sides click into place. |
| 8 | Install the lower dome. Tighten the Phillips pan head screws to secure the lower dome to the back box. |